There is a moment, usually when the low winter sun comes in at a mean angle, when you notice that the underside of your extractor hood has developed a skin. It is tacky to the touch, faintly amber, and it has been building since roughly the last time anyone deep-cleaned the kitchen. Cooking grease does not stay where it is made. It goes up, drifts sideways, and settles as a fine film on the hood, the metal filter, the tiles, the light switch and eventually the ceiling. A quick wipe with a damp cloth just polishes it. What shifts it is heat, soap and a bit of waiting.
Start with the filter, because that is where most of it lives
Turn the hood off at the switch before you touch anything. The mesh or baffle filters usually release with a small spring catch or a tab; slide your hand underneath to support the weight as it comes free, because they are heavier than they look and they are also, at this point, fairly disgusting. Fill the sink or a washing-up bowl with the hottest water your hands can tolerate in gloves, add a generous squeeze of washing-up liquid and a couple of spoonfuls of bicarbonate of soda, and submerge the filter completely. Leave it for at least half an hour. You will see the water change colour, which is grimly satisfying and a good sign. Then scrub with a washing-up brush or an old nail brush, working into the mesh from both sides, rinse under hot running water and leave it to dry fully before it goes back. If the water cools and the grease is still clinging, do it again rather than attacking it with something abrasive, which will damage the mesh.






