Let steam and time do the heavy lifting
Grease responds far better to warmth and moisture than to muscle. Put an ovenproof dish of water in the cold oven, heat it to a low temperature for around twenty minutes, then switch off and let it sit until the cavity is warm but not hot. The steam softens the sticky film so that a cloth lifts it rather than smears it. Do this with the extractor on or a window ajar, simply because warm oven smells are strong.
For an enamel interior, follow the steam with a thick paste of bicarbonate of soda and a little water. Spread it over the floor and walls, avoiding the heating element, the fan and any exposed metal coil, and leave it for a few hours or overnight. The paste dries, holds moisture against the grime and gives you something to wipe away rather than something to fight. Rinse with a damp cloth several times; the last trace of powder is what leaves a chalky bloom later.
The racks, the door and the bit everyone skips
Racks are best soaked. Line a bath or a large tub with an old towel to protect the surface, lay the racks in, cover with hot water and a generous squeeze of washing-up liquid, and leave them for an hour or two. A cheap nylon brush then shifts most of the burnt-on residue. If your bathroom is small, a heavy-duty bin bag on the balcony works: soak, seal, wait, then rinse thoroughly outside.
The glass door usually looks worse than the cavity because we see it every day. Warm soapy water and a soft cloth in circles, then a second pass with clean water, is enough for most doors. Resist scraping with anything metallic. And the bit almost everyone skips: the door seal and the frame around it. Wipe the rubber gasket gently with soapy water rather than paste, because a degraded seal lets heat escape and makes everything you bake slightly less reliable.






