Hot fat, hot tray, and room to breathe
Put your fat — goose fat, beef dripping, a neutral oil with a high smoke point, or olive oil if that's your preference — in the roasting tray and heat the tray in the oven until the fat shimmers. Potatoes going into cold fat absorb it and stew. Potatoes hitting hot fat sizzle instantly and start forming a shell.
Turn each one to coat it, then space them out so no two are touching. A crowded tray traps steam, and steam is the enemy of every crust you're trying to build. Two half-full trays beat one heaving one every single time. Roast hot, turn them once about two thirds of the way through, and resist the urge to keep opening the door. Salt at the end, not at the start — early salt draws moisture to the surface.
Timing them around everything else
The honest difficulty of a roast is that the potatoes want a hot oven while something else wants a gentler one. Work around it: parboil, chuff and cool the potatoes in the morning, then keep them in the fridge uncovered so the surfaces dry further. Twenty minutes of drying air does them nothing but good.
If the oven is occupied while the meat rests, that's your window. Push the heat up and give the potatoes the whole shelf. And if they finish slightly early, leave them in the tray in a single layer somewhere warm rather than piling them into a covered dish, where they'll soften in their own steam within minutes.
Can I prepare roast potatoes the day before?
Yes, and they're often better for it. Parboil, drain, steam-dry and roughen them up, then spread them on a tray and refrigerate uncovered overnight. The surface dries out, which helps the crust form, and on the day you only need hot fat and the oven.
Why do my potatoes stick to the tray?
Usually because the fat wasn't hot enough when they went in, or there wasn't enough of it to coat the base properly. A thin, cold film lets the starch bond directly to the metal. Preheat the tray with the fat until it shimmers, use a sturdy tray rather than a thin flexible one, and when you turn them, slide a metal spatula underneath rather than pulling at them with tongs.











