Spray arms, seals and the parts nobody looks at
Next, spin the spray arms with your hand. They should turn freely. Hold them up to the light and check the small holes: limescale and fruit seeds block them, and a blocked arm means one corner of your load never gets properly washed. A cocktail stick or a straightened paperclip clears them in a minute. On most machines the arms unclip for a proper rinse.
Then the door. Run a damp cloth around the rubber seal, into the folds, and along the bottom lip of the door frame — the strip below the tub that the spray never reaches. This is where the smell lives. If there is dark residue, a cloth with a little white vinegar shifts it. Wipe the detergent dispenser flap too, especially if you use tablets that sometimes fail to release.
Then run it empty and hot
With the machine clean and empty, place a heatproof cup of white vinegar upright on the top rack and run the hottest cycle. The heat plus acid loosens the greasy film and light limescale on the interior. If your water is hard and the inside has a chalky bloom, this is the step that earns its keep. Some people prefer a proprietary dishwasher cleaner, which is fine — just do not combine products in the same cycle.
If odour is the main complaint rather than scale, sprinkle a couple of tablespoons of bicarbonate of soda across the floor of the tub and run a short hot cycle afterwards. Do it as a separate run, not in the same load as the vinegar.






