The half-hour method, window by window
Start dry, always. Wet dust becomes mud and mud goes everywhere. Vacuum the channel with the narrow crevice nozzle, then go along it with a dry paintbrush or an old toothbrush to lift what the nozzle missed, and vacuum again. Only now reach for water.
Warm water with a squeeze of washing-up liquid is enough for ninety per cent of this. Dip the toothbrush, scrub along the groove, and for the corners — where the worst of it compacts — wrap a thin cloth around the end of a chopstick or a butter knife and run it right into the angle. Cotton buds are useful for the final millimetre. Wipe everything out with a damp microfibre cloth, then go over it with a dry one, because leaving moisture in the channel on a cold night rather defeats the purpose.
If there is a stubborn chalky build-up, let a little warm soapy water sit in the channel for ten minutes to soften it rather than attacking it with anything abrasive. Scratched plastic frames collect dirt faster afterwards, so patience beats force here.
The two things to do before you move on
First, find the drainage slots. Open the window and look along the outer edge of the bottom frame for small rectangular openings, sometimes behind a hinged cover. Clear them with the toothbrush — not with wire, which can damage the channel — then pour a cup of water into the inside track and watch it leave. If it does not leave, that is your actual problem, and it is worth sorting now rather than in January.





